This video shows how to wire an L6-30P plug onto the power cord of a THEO MA1 handheld laser welder in the US. The MA1 needs 200 to 240 V AC, single phase.
What you need
- An L6-30P plug.
- A screwdriver for the plug screws.
- An outlet with 200 to 240 V AC, single phase, that matches the plug. The video uses the facility’s 220 V outlet.
Plug and circuit requirements by country are in the Get Ready for Delivery guide.
Wire the plug
- Loosen the screws on the plug’s faceplate and remove the back housing.
- Slide the back housing onto the power cord before you wire anything.
- The terminals on the back of the faceplate are labeled G, X and Y. Connect the PE (ground) wire to G.
- Connect the L wire to X and the N wire to Y. The video notes that the order of these two does not matter; this is the presenter’s habit.
- Push the back housing up onto the plug and tighten the three faceplate screws.
- Fit the cord clamp.
Plug in
Plug the MA1 into your 200 to 240 V AC single-phase outlet. The machine now has power. The next steps, shielding gas and the first start, are in Unboxing and Setup (US).
More THEO MA1 Series tutorials
Questions about your machine? Get support in the Application THEO Toolbox for iOS and Android.