This video gives general guidance on connecting a THEO MA1 handheld laser welder to your shielding gas: the tubing in the box, fittings, the gas flow you need, and how to switch quickly between argon and nitrogen.
Tubing in the box
The MA1 comes with 10 mm OD tubing and a reducer from 10 mm to 6 mm OD. The gas inlet on the back of the MA1 is a 6 mm hard line.
The video keeps it simple with a 6 mm OD line all the way. On the regulator side, a 1/4 in flare to 3/8 in pipe thread adapter leads to a 3/8 in pipe thread 90-degree elbow with a 6 mm push-to-connect fitting. The elbow lets you route the line freely without putting stress on the plumbing. If you would rather stay with 10 mm OD tubing, mix and match the fittings you need.
What counts: a tight seal and enough flow
Whatever fittings you choose, the connection must seal tightly, must not leak, and must deliver about 12 l/min (25 cubic feet per hour, cfh) of gas at the torch. You connect your own gas delivery system to the 6 mm line on the back of the MA1.
Switch between argon and nitrogen
If you weld both steel and aluminum, you may want to switch quickly between nitrogen and argon. A 6 mm OD push-to-connect tee does it: argon into one side, nitrogen into the other, the third port to the MA1.
Then either run a regulator on each cylinder and switch between them, or close one cylinder valve, purge the first gas from the line, open the other cylinder and let it fill the line before you start the next job.
More THEO MA1 Series tutorials
- MA1 Gas Plumbing Guide (US)
- Unboxing and Setup (US)
- Power Connection (US)
- Get Ready for Delivery (guide)
Questions about your machine? Get support in the Приложението THEO Toolbox for iOS and Android.